fender flares

[machiel de bruyn]

i'm urgently looking for a set of fender flares. I any one know where i can them, plz let me know...

[Gelände]

Andrew showed me a "generic" rubber strip you can use...it also doesn't require any drilling. PM him?

[machiel de bruyn]

thx but I'm looking for the original flares... was looking to buy Andrew's set but I was a little late.

[Gelände]

Andrew's solution is better IMO. Easier to fit, and flexes much better.

[Gelände]

Here is a pic, not "trimmed", only to indicate the profile.

[Andrew]

I may have a set of flares in a parcel of spares I bought last week. I know nothing of condition or if bumper corners are included but if I get them I will advise you.

[Riaan Harman]

Andrew

Do you have some of those strips I want to try and fit them and see if one can't nicely round off the ends.

Thanks

R

[Andrew]

Yes I have got some here.

And maybe we can start a new thread with a couple of guys trying to make the plan work and swop ideas until it works.

It comes from Rubberite in Mitchell street and is about R100/m and really is a good quality profile - looks like something that could be OEM.

There is also a profile that is almost identical to the sill strip under the door. It has an aluminium backing that can screw into the existing holes and then the rubber strip slides / clips into that. Once again the ends are the problem.

[Chris Ebersohn]

Hi Andrew, I'm also interested in these strips, both types actually, have you been able to make a plan with the ends etc.? Chris.

[Marius Grobler]

Yes I have got some here.

And maybe we can start a new thread with a couple of guys trying to make the plan work and swop ideas until it works.

It comes from Rubberite in Mitchell street and is about R100/m and really is a good quality profile - looks like something that could be OEM.

There is also a profile that is almost identical to the sill strip under the door. It has an aluminium backing that can screw into the existing holes and then the rubber strip slides / clips into that. Once again the ends are the problem.

HI Andrew I would also be very interested. Can we get them from you and have you been able to make a plan with the ends?